Grade	H-100 General CCO Plate
Wear condition	Ordinary abrasion, low to medium impact
Typical hardness	HRC 58-65
Common thickness	6+4, 8+6, 10+8, 10+10 and customized
Main applications	Chutes, hoppers, conveyor liners, cement equipment

Reliable general-grade wear plate for common abrasive flow

HALDEN H-100 General CCO Plate is made by depositing a chromium carbide hardfacing layer on a weldable steel base plate. The overlay layer provides abrasion resistance, while the base plate supports cutting, bending, welding and installation into industrial equipment.

This grade is suitable for bulk material handling positions where sliding abrasion is the main wear mode and impact is not severe. It is commonly used as replacement liner material for cement, mining, aggregate, recycling, port and power plant equipment.

Key benefits

• Good balance between wear resistance, cost and fabrication flexibility
• Suitable for flat liners and simple fabricated wear parts
• Can be cut, drilled, welded, bent or supplied with studs
• Available as full plates or ready-to-install liner kits

Typical specifications

Overlay type	Chromium carbide hardfacing layer
Base plate	Q235, Q345, A36 or equivalent weldable steel
Hardness	Typically HRC 58-65 on overlay surface
Plate format	Standard sheet or cut-to-size liner
Processing	Cutting, bending, rolling, drilling, stud welding, welding assembly

Recommended applications

Use H-100 where abrasion is predictable and the installation position does not receive heavy direct impact.

Chute liners For sliding material transfer points in cement, mining, aggregate and port systems.	Hopper liners For storage and feeding equipment handling clinker, ore, coal, slag or aggregate.
Conveyor liners For conveyor skirt boards, transfer stations and material handling wear zones.	Cement equipment For raw material, clinker, limestone and coal handling areas with abrasive flow.
General liner kits Cut, drilled and marked liners supplied according to installation drawings.	Wear repair projects Useful when customers need a fast upgrade from mild steel or short-life plates.

When to choose H-100

Condition	H-100 suitability	Recommendation
Ordinary abrasive material flow	Good fit	Use H-100 as the standard CCO liner grade.
Severe ore abrasion with low impact	May be limited	Consider H-200 Severe Abrasion Plate.
Fine powder, slurry or sticky material	Possible, but not ideal	Consider H-300 Smooth Surface CCO Plate.
High temperature wear area	Not the first choice	Consider H-400 High Temperature Plate.
Heavy impact at loading or crusher zones	Not recommended	Consider H-500 Impact Resistant Plate.